Delta Retrofit sumps are fitted with a dual pump system and have three 110mm side inlets to take ground water, and grey water from shower, laundry and sink waste

When specifying a sealed cavity membrane system, full consideration must be given to drainage, when installed below ground.

The concept of the drained cavity system is to collect and manage any moisture which breaches the integrity of the structure by channeling, collecting, and discharging such free water via a suitable evacuation point."

Channels, laid to a nominal fall, can discharge passively into a sump or be connected to a drainage system but access for maintenance should be provided.

Access ports allow inspection and water jetting of channels, while sumps have a sealed access cover which allows for annual maintenance checks to be carried out, which are recommended.

If drainage has been installed, it should be flood tested before covering it up to make sure the system works.

Delta offer a choice of sump+pump stations to fit the purpose, and free advice is available from their technical staff.

Delta Aquaduct is a drainage channel which acts as a perimeter conduit bedded in at the floor/wall angle. Where appropriate, it can be laid under the slab to take off ground water to a sump or soak away, and reduce flotation pressures from baring on the slab.

Delta Aquaduct is fully perforated for maximum performance, and incorporates an outer geotextile filter to prevent particles

From entering the channel. The product comes on a roll 150m x 60mm diameter. It is also available in 100m x 100mm dia rolls.

Delta Channel is a water collection conduit which is bedded into a preformed channel at the floor/wall angle. Holes in the channel wall allows water to ingress at this point to drain away to a sump or soak away. Access ports are available to allow maintenance and inspection.

If you've installed a cavity drained system internally, one of the main design considerations is how are you going to manage the water collection and discharge. This can be done passively into existing drainage points, if available and appropriate.


However, the majority of projects require a collection sump + pump, to automatically manage the evacuation of any water ingress. This type of unit requires mains power to operate, so what can be done if the power fails, and is coincident with high water ingress? Here are two options from Delta.

High water level alarm - This system gives an audible warning if a high level situation occurs. It is fitted with it's own rechargeable battery, which is trickle charged , and will still operate in the event of mains power failure.

Delta Power-Pack -This unit is designed to run the pumps if a power failure occurs. The unit is trickle charged under normal conditions, and will auto switch to battery power if mains power fails. The unit will pump approx. 8,910 litres in back up mode but this can be upgraded by adding up to ten extra power units. Adding one unit raises the capacity to 27,300 litres.