Waterproofing structures offers protection to structural components, buildings, and installations from the penetration of water; it reduces risk and will prolong the life time of the structure.  However, some below ground construction projects require protection from both water ingress and gas contamination.

It’s now possible to produce a waterproofing design which incorporates both a waterproof and gas proof protection system, however these types of projects require a different strategy and methodology as to what would be classed as a typical waterproofing design.  Both BS 8102:2022 and BS 8485:2015+A1:2019 are intertwined.  Basements and below ground structures which need to be watertight and gas proof are not anymore complex to design but require further considerations at the design phase and throughout the project.

The object of structural waterproofing is to protect a structure for its lifetime from water ingress.

The object of ground gas protection is to prevent a build-up of gasses against a structure.

Combining Waterproofing Design with Ground Gas Protection

Innovations within the waterproofing sector have seen the introduction of Ground Gas Protection Systems, which are capable of offering both gas protection and waterproof solution.

A Waterproofing Design Specialist will be able to interpret the requirements of BS8102:2009 and BS8485:2015 to produce a waterproofing design which incorporates both a waterproof and gas proof protection system.

Characteristic Situation Score and Hazard Assessment

If a site has been identified with a gas or hydrocarbon contamination it will have been given a Characteristic Situation Score.  The Characteristic Situation Score is defined according to how severe the gas flow from the ground is.

All sites which have been characterised with a gas situation score will require a gas protection system and where identified a waterproof protection barrier.

Methods of Gas Protection

Gas protection is a technical solution to prevent or to control gas penetration into properties. The control of gas migration is normally achieved by blocking the pathway or removing the source of the gas generation. There are several methods available to achieve the protection to existing/new build properties.

Gas protection measures available to achieve the minimum points score requires a combination of two or more of the following protection measures be used:

  • The Structural Barrier
  • Ventilation Measures
  • Gas Resistant Membrane

Methods of Structural Waterproofing

 There are 3 Types of waterproofing methods.  These are defined as:

  • Type A Tanked or Barrier Protection. Cementitious or bitumen-based products applied internally, externally or sandwiched within the structure.
  • Type B Structurally Integral Protection. Reinforced or prestressed concrete designed through composite and integrated details such as water bars to be water resistant.
  • Type C Drained Protection. Cavity Drainage Systems which allow for water ingress but in a controlled fashion.

 Evaluation of groundwater conditions, risk assessment and options for drainage outside the structure should always be considered.

Chat with a member of our team

Get in touch